First start by removing the plastic cover, you can use a flathead screwdriver, but the fastener removal tool makes this process much easier. Once you’ve removed the plastic cover, you’ll remove the grille. Remove the four bolt with a socket.
After removed all four bolts, pull the grille with a little bit of force. Next is the headlights, there are two bolts on the front.
Remove the bolts with ten millimeter socket, when those are removed, remove the plastic clip that is located under the wheel. After removed the clip reach in and push the white tab up. This will release the headlight. You will hear a click when you push up.
Once released the tab, pulled the headlight out and remove the wiring harness by pushing the tab in. It is the same to the another headlight housing. Remove the front two bolts, remove the plastic clip under the wheel and push the tab up and release the headlight.
Removing the dust cover with an 8 millimeter socket, after removing the dust cover, removing the low beam. Twisting the bulb counterclockwise, then unclip the wiring harness from the bulb, the low beam headlight bulbs in car are 9005 base.
After lining up the H11 LED bulbs, turn the bulb clockwise. Once the bulb is in place, connect the wiring harness to the LED bulb. Next remove the high beam by twisting counterclockwise. The high beam headlight bulbs are 9005 base.
Unclip the wiring harness from the bulb. Before installing the high beams, you’ll want to adjust the bracket so that the LED bulbs fit incorrectly. Pushing down and twisting intelligence in the correct position. When the 9005 LED bulbs are positioned correctly, line up the LEDs and twist clockwise. Once the LEDs are secured connect their wiring harness to the LED bulbs. When the connection is secure, we place the rest of the wiring harness and driver inside the lamp, that can properly attach the dust cover. Repeat these steps with the other headlight.
